HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 811
GbE Ports. For each GbE Port, the display includes the destination IPv4 Address, detail, ip-address
View all HP Brocade 8/12c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 811 highlights
22 portShow -d | --detail Displays a full view configuration details for all configured tunnels when used with the all port specifier. This view provides an alternative to specifying a specific VE_Port or to using the --perf option for a comprehensive view. -I | --ip-address Displays the IP addresses configured the specified circuits. You must use this option with either the --summary or the --circuit option. fcipcircuit Displays FCIP circuit configuration and status. The following operands are supported with portShow fcipcircuit: circuit_ID Specifies a single circuit within the FCIP tunnel. The circuit ID is an integer value between 1 and 19 on the Brocade FX8-24 and 1 and 7 on the Brocade 7800. This operand is required. -t | --tcp Displays the TCP statistics for the specified circuit. -p | --perf Displays additional performance information for the specified FCIP circuit. -q | --qos Displays the QoS statistics including performance for each priority. This operand is optional with the --perf option. mgmtif Displays the inband management interfaces configured for a specified GbE Port or for all GbE Ports. For each GbE Port, the display includes the interface status (enabled or disabled), the interface IPv4 Address, the netmask, effective MTU, and annotated port flags. mgmtroute Displays the management routes configured for a specified GbE Port or for all GbE Ports. For each GbE Port, the display includes the destination IPv4 Address, the netmask, the gateway address, and annotated port flags. The metric field is not valid for the Brocade 7800. xtun Displays FICON and FCP emulation statistics and current runtime conditions for a specified set of parameters. The following arguments are supported: -fcp Displays the SCSI FastWrite/Tape Pipelining command sub-menu when issued with a VE_Port number. The syntax for -fcp is as follows: portshow xtun [slot/]\ve_port -fcp [level] [command] [param] [options] The following optional operands are supported with -fcp to display FCP emulation statistics and status information: -help Displays the command usage. You must specify a VE_Port number to display the help functions, for example: portshow xtun 7/12 -fcp -help. level Specifies the level for which information is displayed. You can specify one or more of the following levels. With each additional level, this command generates progressively more information. -port Displays data at the port level. Fabric OS Command Reference 777 53-1001764-01