HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 261

22 dlsSet The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. OPERANDS --enable -lossless --disable -lossless --help Enables the Lossless feature. Frame loss is reduced while the path is rerouted. If DLS is set on the switch, this command adds the Lossless feature to the existing DLS legacy mode. If DLS is not set on the switch, this command enables both DLS and the Lossless feature. The Lossless feature is disabled by default. Disables the previously enabled Lossless feature. Execution of this command is equivalent to the legacy dlsSet command. Dynamic load balancing is enforced but not without frame loss. DLS (legacy mode) continues to be enabled after Lossless is disabled. Use dlsReset to disable DLS completely. Displays the command usage. EXAMPLES DLS configuration commands on a switch with an exchange-based policy: switch:admin> aptpolicy Current Policy: 3 0(ap) 3 0(ap) : Default Policy 1: Port Based Routing Policy 3: Exchange Based Routing Policy 0: AP Shared Link Policy 1: AP Dedicated Link Policy switch:admin> dlsshow DLS is set by default with current routing policy DLS is set with Lossless enabled switch:admin> dlsreset DLS can not be changed with current routing policy switch:admin> dlsset DLS can not be changed with current routing policy switch:admin> dlsset --enable -lossless Lossless is set switch:admin> dlsset --disable -lossless Lossless is not set switch:admin> dlssshow DLS is set by default with current routing policy Fabric OS Command Reference 227 53-1001764-01