HP C3180A Service Manual - Page 20
Power Requirements, Choosing an Interface Cable - designjet 200 manual
View all HP C3180A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Power Requirements HP C3180A and C3181A DesignJet 200 and HP C3187A and C3188A DesignJet 220 plotters have selfĆadjusting power supplies and do not require a voltage selector or switch settings prior to use. The table below lists the power requirements for the plotters. Source Voltage Requirements: Frequency: Consumption: Power Requirements Voltage Max current (rms) 100 V ac 120 V ac 220 V ac 240 V ac 1.4 A 1.2 A 650 mA 600 mA 47-53 Hz and 57-63 Hz 140 watts maximum WARNING The ac power outlet (mains) must have a protective earth (ground) terminal. Serious shock hazard leading to death or injury may result if the plotter is not properly grounded. The power cord supplied with the plotter should meet the plug requirements for the geographical area. However, different power cords (international options) are available. (Cable part numbers ' chapter 10.) Choosing an Interface Cable (Instructions ' User's Guide, chapter 1, w Choosing an interface cable.) Serial (RSĆ232ĆC) Interface A short cable (less than 15 meters or 50 feet) is recommended for the RSĆ232ĆC interface. A longer cable is permissible, provided the load capacitance does not exceed 2500 picofarads. Parallel (BiĆTronics/Centronics) Interface Use a short cable (less than 2 meters or 6.6 feet) for the parallel interface. (Interface descriptions ' Service Manual, chapter 5, w Input/Output Interfaces.) (Pin specifications ' User's Guide, chapter 6, w Interface specifications.) (Cable part numbers ' Service Manual, chapter 10.) 2Ć2 Site Planning and Requirements C3187Ć90000