HP Cisco MDS 9216i Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 1142

ssm enable feature dmm Chapter 22 Show Commands Send documentation comments to [email protected] ssm enable feature dmm To enable DMM, use the ssm enable feature dmm command in configuration mode. To disable DMM, use the no form of the command. ssm enable feature dmm {force {interface fc slot/port | module slot} | interface fc slot/port | module slot} no ssm enable feature dmm {force {interface fc slot/port | module slot} | interface fc slot/port | module slot} Syntax Description force interface fc slot/port module slot Forces a switching module reload. Specifies the interface. Specifies the Fiber Channel slot and port numbers. Specifies the SSM module slot number. Defaults Disabled. Command Modes Configuration mode. Command History Release 3.2(1) Modification This command was introduced. Usage Guidelines Starting with NX-OS 4.1(1b), DMM must be enabled using the ssm enable feature dmm command before using the SLD tool. Examples The following example shows how to enable DMM on a module: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# ssm enable feature dmm module 1 The following example shows how to enable DMM on an interface: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# ssm enable feature dmm interface fc 1/1 - 4 The following example shows how to force a reload on some of the ports on a module: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# ssm enable feature dmm force interface fc 1/1 - 8, fc 1/13 - 16 22-74 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x