HP Cisco MDS 9216i Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 765

Chapter 14 L Commands line com1 Send documentation comments to [email protected] line com1 To configure auxiliary COM 1 port, use the line com1 command. To negate the previously issued command or to revert to factory defaults, use the no form of the command. line com1 --> databits number | flowcontrol hardware | modem {in | init-string {default | user-input} | set-string user-input string} | parity {even | none | odd} | speed speed | stopbits {1 | 2} line com1 --> no databits number | no flowcontrol hardware | no modem {in | init-string | set-string user-input} | no parity {even | none | odd} | no speed speed | no stopbits {1 | 2} Syntax Description databits number Specifies the number of databits per character. The range is 5 to 8. flowcontrol hardware Enables modem flowcontrol on the COM1 port. modem Enables the modem mode. in Enables the COM 1 port to only connect to a modem. init-string default Writes the default initialization string to the modem. set-string user-input Sets the user-specified initilization string to its corresponding profile. string Maximum length is 80 characters. init-string user-default Writes the provided initialization string to the modem. parity Sets terminal parity. even Sets even parity. none Sets no parity. odd Sets odd parity. speed speed Sets the transmit and receive speeds. The range is 110 to 115, 200 baud. stopbits Sets async line stopbits. 1 Sets one stop bit. 2 Sets two stop bits. Defaults 9600 Baud 8 databits 1 stopbit Parity none Default init string OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 14-3