HP Cisco MDS 9216i Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 865

Chapter 18 P Commands port-type Send documentation comments to [email protected] port-type To configure port type policies, use port-type command. To disable port type policies, use the no form of the command. port-type {all | trunks | access-Ports} no port-type {all | trunks | access-Ports} Syntax Description access ports all trunks Configures only access ports. Configures both trunk ports and access ports. Configures only trunk ports. Defaults None. Command Modes Configuration mode. Command History Release 4.1(1b) Modification This command was introduced. Usage Guidelines The default policy uses its own internal port type, which is the same as all ports. Examples The following example shows how to configure port monitoring for access ports: switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch(config)# port-monitor name cisco switch(config-port-monitor)# port-type access-port trying to get name name is cisco sending port type access switch(config-port-monitor)# The following example shows how to configure port monitoring for all ports: switch(config-port-monitor)# port-type all trying to get name name is cisco sending port type all switch(config-port-monitor)# The following example shows how to configure port monitoring for trunk ports: switch(config-port-monitor)# port-type trunks trying to get name name is cisco sending port type trunks switch(config-port-monitor)# OL-18089-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family Command Reference 18-33