HP Cisco MDS 9500 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 1006

system default zone default-zone permit Chapter 21 S Commands Send documentation comments to [email protected] system default zone default-zone permit To configure default values for a zone, use the system default zone default-zone permit command in configuration mode. To revert to the defaults, use the no form of the command. system default zone default-zone permit no system default zone default-zone permit Syntax Description This command has no arguments or keywords. Defaults No default values for zones. Command Modes Configuration mode. Command History Release 3.0(1) Modification This command was introduced. Usage Guidelines This command defines the default values for the default zone for all VSANs. The default values are used when you initially create a VSAN and it becomes active. If you do not want to use the default values, use the zone default-zone permit vsan command to define the operational values for the default zone. The system default zone default-zone permit command should only be used in conjunction with VSANs that have not yet been created; it has no effect on existing VSANs. Note Because VSAN 1 is the default VSAN and is always present, this command has no effect on it. Examples The following example sets the default zone to use the default values. switch# config terminal switch(config)# system default zone default-zone permit The following example restores the default setting. switch(config)# no system default zone default-zone permit Related Commands Command zone default-zone permit vsan show system default zone Description Defines whether a default zone (nodes not assigned a created zone) permits or denies access to all in the default zone. Displays default values for the default zone. 21-88 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x