HP Cisco MDS 9500 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 943

Chapter 21 S Commands setup Send documentation comments to [email protected] setup To enter the switch setup mode, use the setup command in EXEC mode. setup Syntax Description This command has no arguments or keywords. Defaults None. Command Modes EXEC mode. Command History Release 1.0(2) Modification This command was introduced. Usage Guidelines Refer to the Cisco MDS 9000 Family CLI Configuration Guide for more information on using the setup command. The setup utility guides you through the basic configuration process. Type Ctrl-c at any prompt to skip the remaining configuration options and proceed with what is configured to that point. If you do not want to answer a previously-configured question, or if you want to skip answers to any questions, press Enter. If a default answer is not available (for example switch name), the switch uses what is already configured, and skips to the next question. Examples The following example shows how to enter switch setup mode. switch# setup ---- Basic System Configuration Dialog ---- This setup utility will guide you through the basic configuration of the system. Setup configures only enough connectivity for management of the system. *Note: setup always assumes a predefined defaults irrespective of the current system configuration when invoked from CLI. Press Enter incase you want to skip any dialog. Use ctrl-c at anytime to skip away remaining dialogs. Would you like to enter the basic configuration dialog (yes/no): yes OL-16217-01, Cisco MDS SAN-OS Release 3.x Cisco MDS 9000 Family Command Reference 21-25