HP Cisco MDS 9500 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 1170

show install all status Chapter 22 Show Commands Send documentation comments to [email protected] show install all status To display the on-going install all command status or the log of the last installed install all command from a Console, SSH, or Telnet session, use the show install all status command. show install all status Syntax Description This command has no arguments or keywords. Defaults None. Command Modes EXEC mode. Command History Release 1.3(1) Modification This command was introduced. Usage Guidelines This command only displays the status of an install all command that is issued from the CLI, not the Fabric Manager. The show install all status command also displays the status of nondisruptive software upgrades on the Cisco MDS 9124 Fabric Switch (after the switch has rebooted and comes up with the new image). Actions that occurred before the reboot are not displayed in the output. So, if you issue the install all command via a telnet session, the telnet session will be disconnected when the switch reboots. After you reconnect to the switch using telnet, the upgrade may already be complete; in this case, the show install all status command will display the status of the upgrade. Examples Use the show install all status command to view the output of a install all command process. switch# show install all status There is an on-going installation in progress installation Enter Ctrl-C to go back to the prompt. Verifying image bootflash:/b-1.3.0.104 -- SUCCESS Verifying image bootflash:/i-1.3.0.104 -- SUCCESS Extracting "system" version from image bootflash:/i-1.3.0.104. -- SUCCESS Extracting "kickstart" version from image bootflash:/b-1.3.0.104. -- SUCCESS 22-138 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x