HP Cisco MDS 9500 Cisco MDS 9000 Family Command Reference - Cisco MDS SAN-OS R - Page 332

Chapter 5 D Commands do Send documentation comments to [email protected] do Use the do command to execute an EXEC-level command from any configuration mode or submode. do command Syntax Description command Specifies the EXEC command to be executed. Defaults None. Command Modes All configuration modes. Command History Release 1.1(1) Modification This command was introduced. Usage Guidelines Use this command to execute EXEC commands while configuring your switch. After the EXEC command is executed, the system returns to the mode from which you issued the do command. Examples The following example disables the terminal session-timeout command using the do command in configuration mode. switch(config)# do terminal session-timeout 0 switch(config)# The following example create, enables, and displays the interface from configuration mode. switch(config)# int fc 3/1 switch(config-if)# no shut switch(config-if)# do show interface fc 3/1 fc3/1 is trunking Hardware is Fibre Channel Port WWN is 20:81:00:05:32:00:4a:9e Peer port WWN is 20:43:00:0c:88:00:4a:e2 Admin port mode is auto, trunk mode is on Port mode is TE Port vsan is 1 Speed is 2 Gbps Transmit B2B Credit is 0 Receive B2B Credit is 255 Receive data field Size is 2112 Beacon is turned off Trunk vsans (admin allowed and active) (1-10) Trunk vsans (up) (1-10) Trunk vsans (isolated) () Trunk vsans (initializing) () 5 minutes input rate 504 bits/sec, 63 bytes/sec, 0 frames/sec 5 minutes output rate 344 bits/sec, 43 bytes/sec, 0 frames/sec 69390 frames input, 4458680 bytes 5-34 Cisco MDS 9000 Family Command Reference OL-16217-01, Cisco MDS SAN-OS Release 3.x