HP Designjet L28500 HP Designjet L28500 Printer Series - Site preparation guid - Page 5

Overview, Introduction, Customer responsibilities, Installation time schedule - review

Get HP Designjet L28500 PDF manuals and user guides View all HP Designjet L28500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

1 Overview Introduction Your printer is supplied ready to use after a few simple installation procedures described in detail in the Assembly instructions. It is important to read the information provided in this guide thoroughly and to ensure complete compliance with all installation and operation requirements, safety procedures, warnings, cautions and local regulations. A well prepared site helps to provide a smooth and easy installation. Customer responsibilities You are responsible for preparing the physical site for the installation of the printer. 1. Prepare the building's electrical system to meet the printer's requirements and the Electrical Code requirements according to the local jurisdiction of the country where the equipment is installed, and power up the printer on the day of installation. See Electrical configuration on page 4. NOTE: Make sure that a certified electrician reviews the setup and configuration of the electrical system used to power the printer. See Electrical configuration on page 4. 2. Meet all requirements for RIP, networking and printing supplies. See RIP workstation characteristics on page 4, Networking on page 4 and Printing supplies on page 4. 3. Meet temperature and humidity requirements and ensure proper ventilation for the printer. See Environmental specifications on page 3. 4. Prepare the unloading route so the printer can be unloaded and maneuvered into place. See Unloading route on page 2. Installation time schedule Allow a minimum of three hours for the installation. NOTE: The installer may require help from another person to perform certain tasks during installation. ENWW Introduction 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
1
Overview
Introduction
Your printer is supplied ready to use after a few simple installation procedures described in detail in the
Assembly instructions
. It is important to read the information provided in this guide thoroughly and to
ensure complete compliance with all installation and operation requirements, safety procedures,
warnings, cautions and local regulations. A well prepared site helps to provide a smooth and easy
installation.
Customer responsibilities
You are responsible for preparing the physical site for the installation of the printer.
1.
Prepare the building's electrical system to meet the printer's requirements and the Electrical Code
requirements according to the local jurisdiction of the country where the equipment is installed,
and power up the printer on the day of installation. See
Electrical configuration
on page
4
.
NOTE:
Make sure that a certified electrician reviews the setup and configuration of the electrical
system used to power the printer. See
Electrical configuration
on page
4
.
2.
Meet all requirements for RIP, networking and printing supplies. See
RIP workstation characteristics
on page
4
,
Networking
on page
4
and
Printing supplies
on page
4
.
3.
Meet temperature and humidity requirements and ensure proper ventilation for the printer. See
Environmental specifications
on page
3
.
4.
Prepare the unloading route so the printer can be unloaded and maneuvered into place. See
Unloading route
on page
2
.
Installation time schedule
Allow a minimum of three hours for the installation.
NOTE:
The installer may require help from another person to perform certain tasks during installation.
ENWW
Introduction
1