HP Dx2250 Hardware Reference Guide - dx2250 MT - Page 18

Replacing or Upgrading a Drive The computer supports up to five drives that may be installed in various configurations. This section describes the procedure for replacing or upgrading the storage drives. A Torx T-15 screwdriver is needed to remove and install the guide screws and retainer screws on a drive. Locating Drive Positions NOTE The drive configuration shown below may be different than your computer model. Figure 2-8 Drive Positions 1 External 5.25-inch full-height optical drive bay 2 External 5.25-inch full-height option drive bay 3 External 3.5-inch option drive bay (media card reader shown)1 4 Internal 3.5-inch one-third height bay for optional secondary hard drive 5 Internal 3.5-inch one-third height bay for primary hard drive 1 The external 3.5" option drive bay accommodates a diskette drive or a media card reader. 12 Chapter 2 Hardware Upgrades ENWW