HP HP-380467-003 Upgrading and Servicing Guide - Page 6
After Closing the PC, Removing the Side Panel, See Before Opening
UPC - 846084030171
View all HP HP-380467-003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3 Disconnect the modem/telephone cable, if present. WARNING: To reduce the risk of personal injury from electrical shock or hot surfaces, disconnect the power cable from the wall outlet, and allow the internal system components to cool before touching. 4 Disconnect the power cable from the electrical outlet, and then from the PC. 5 Disconnect all other attached cables (such as the keyboard, mouse, and monitor) and all external devices. CAUTION: Static electricity can damage the electronic components of the PC or optional equipment. Ensure that you are discharged of static electricity by briefly touching a grounded metal object. After Closing the PC To avoid injury and equipment damage, always follow this procedure in this order after closing the PC: 1 Reconnect the power cable. WARNING: To reduce the risk of electrical shock, fire, or damage to the equipment, do not plug telecommunications or telephone connectors into the network interface card (NIC) (labelled as an Ethernet connector). 2 Reconnect the modem/telephone cable and all other attached cables (such as the keyboard, mouse, and monitor) and external devices. 3 Turn on the PC and all peripherals. 4 If you installed an add-in card, install any software drivers supplied by the card manufacturer. Removing the Side Panel 1 See "Before Opening the PC" on page 1. 2 Loosen the two thumbscrews on the right side of the back panel. The first time you loosen these screws, you may need to use a Phillips screwdriver. WARNING: Beware of sharp edges inside the chassis. 3 Slide the panel back about 2.5 cm (1 inch), lift it off the unit, and set it aside. NOTE: You do not need to remove the other side panel to replace the hardware listed in this guide. Replacing the Side Panel 1 Align the notches inside the side panel with the holes on the chassis frame. 2 Slide the side panel forward on the frame until it locks into place, and then tighten the thumbscrews on the side panel. 3 See "After Closing the PC" on page 2. 2 Upgrading and Servicing Guide