HP Integrity Superdome 2 16-socket LIFT-O-FLEX® 17000 SP 400 Manual - Page 7

Lift-O-Flex 17000 SP 400 Manual 5. Take the power package and let it slide into the slot on the rear of the lift mast. Then lower it until it stops just above the mast mounting yoke and tighten the handle. Plug the motor cable into its outlet on the power package. 6. Take the handle and let it slide into the slot on the backside of the lift mast and lock it in place at a comfortable height. Make sure that the remote control holder is placed on the handle in an adequate position. Then place the remote control on the remote control holder in the keyhole slot and plug in the controller to the electronic power pack. 7. Lift the end-effector up and tilt the mounting post down so that the mounting lugs can be placed in the slot located at the top of the mast yoke. Make sure that the mounting lugs are seated in the bottom of the slot and then lower the front of the end-effector until the bottom mounting lugs engage the horizontal slot on the mast yoke. The lifter is now ready to operate. Page 6 Rev July 01