HP J7988G HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 61
Config Precedence, TCP/IP Diagnostics
UPC - 882780985582
View all HP J7988G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Table 3-3 Telnet Commands and Parameters (continued) dhcp-fqdn-config (dhcp-fqdn-behavior) NOTE: While supported in this release, this command may be superseded or overridden by the Config Precedence entries accessed through the embedded Web server. Specifies configuration control of the Fully Qualified Domain Name (FQDN), using either DHCP, manual configuration, or both. The fully qualified domain name consists of the device's host name and domain name. Select one of the following command values: 0 (default): DHCP may be used to supply the host name and domain name. The host name may be changed using a manual configuration method (such as the embedded Web server, printer control panel, or Telnet). However, the domain name cannot be manually changed if it was configured through DHCP. 1: Keep DHCP settings only. Once the Fully Qualified Domain Name is configured through DHCP, manual changes cannot be made. 2: Keep manual settings. The settings can be manually configured. DHCP may be used only if the settings are factory-default values. 3: Keep manual settings only. While manual configuration methods may be used, configuration through DHCP is not allowed. duid dns-cache-ttl dhcp-arbitration stateless-dhcpv4 phone-home-config TCP/IP Diagnostics Last Config IP TCP Conns Refused TCP Access Denied DHCP Lease Time Specifies the DHCP Unique Identifier for a client, using a hexadecimal string to represent up to 260 characters. The time-to-live for a cached DNS name, in seconds. Specify a value from 0 to 4294967295 seconds. If 0, names will not be cached. Specifies the amount of time, in seconds, that the print server will wait for DHCP configuration offers. A value from 1 to 10 may be set. The default is 5 seconds. When enabled, allows additional IP parameters to be automatically configured from a DHCPv4 server even when the print server is statically configured (such as a manually configure IP address, subnet mask and default gateway). 0 disables. 1 (default) enables. Specifies privacy settings on the print server during embedded Web server access. This command controls whether statistical data on product use may be sent to HP. For HP to collect data, Internet access is required. 2: Prompt the user to allow sending data on initial access to the Networking tab of the embedded Web server. This is the factory-default and cold-reset value. Once changed, this value cannot be re-selected. 1: Allows the sending of data to HP without prompting the user. 0: Disables sending data to HP without prompting the user. (Read-only parameter) The IP address of the system from which the HP Jetdirect print server's IP address was configured. (Read-only parameter) The number of client TCP connections that are refused by the print server. (Read-only parameter) The number of times that client systems were denied access to the print server because there was no allowable entry in the print server's host access list. (Read-only parameter) DHCP IP address lease duration time (seconds). ENWW IPv4 Configuration 51