HP J7988G HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 83
Network Settings, Apply
UPC - 882780985582
View all HP J7988G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Table 4-8 TCP/IP Advanced tab (continued) Item Description (IPv4 only) Enter Web addresses, host names, or domain names that do not need to be accessed through the proxy server. Use semicolons (;) to separate entries. Default IP (IPv4 only) Specifies the IP address to use when the print server is unable to obtain an IP address from the network during a forced TCP/IP reconfiguration (for example, when manually configured to use BOOTP/DHCP). LEGACY DEFAULT_IP: sets the legacy default IP address 192.0.0.192. AUTO_IP: sets a link-local IP address 169.254.x.x. The initial setting is determined by the IP address obtained when first powered on. Send DHCP requests if IP address (IPv4 only) A checkbox is used to specify whether DHCP requests will be periodically is Auto IP (169.254.x.x) or Legacy transmitted when a legacy default IP address 192.0.0.192 or link-local IP address Default IP 169.254.x.x has been automatically assigned. Clear the checkbox to disable DHCP requests. Check the checkbox (default) to enable DHCP requests. Use Stateless DHCPv4 When Manually Configured (IPv4 only) A checkbox is used to allow additional IPv4 parameters to be automatically configured from a DHCPv4 server even when the print server is statically configured (such as a manually configure IP address, subnet mask and default gateway). Clear the checkbox to disable stateless DHCPv4 configuration. Check the checkbox (default) to enable stateless DHCPv4 configuration. TTL/SLP (IPv4 only) Specifies the IP multicast Time To Live (TTL) discovery setting for Service Location Protocol (SLP) packets. The default value is 4 hops (the number of routers from the local network). The range is 1-15. If set to −1, multicast capability is disabled. For print servers configured for Auto IP (link-local) addresses, this field will be ignored. TTL on outbound packets will always be set to 255 and limited to the link-local network. Syslog Server (IPv4 only) Specifies the IP address of a host computer that is configured to receive syslog messages from the HP Jetdirect print server. If a Syslog Server is not specified, syslog messages are disabled. Syslog Maximum Messages (IPv4 only) Specifies the maximum number of syslog messages that can be sent by the HP Jetdirect print server on a per-minute basis. This setting allows administrators to control the log file size. The default is 10 per minute. If set to zero, no maximum number is defined. Syslog Priority (IPv4 only) Controls the filtering of syslog messages that are sent to the syslog server. The filter range is 0 to 7, with 0 being the most specific and 7 being the most general. Only messages that are lower than the filter level specified (that is, higher in priority) are reported. The default value is 7 which reports all syslog messages. A value of 8 disables syslog reporting. Network Settings The Network Settings pages allow you to set or change configuration parameters for IPX/SPX on page 74, AppleTalk on page 75, DLC/LLC on page 76, and SNMP on page 76 protocols. To assign a parameter setting, enter the desired value and click Apply. NOTE: The features displayed depend on the print server. Value-featured print servers provide limited protocol support. ENWW Networking Tab 73