HP J7988G HP Jetdirect Print Server Administrator's Guide (Firmware V.36) - Page 69
Moving to Another Network (IPv4), Using the Embedded Web Server, Using the Printer Control Panel - jetdirect ipv4 ipv6 print server
UPC - 882780985582
View all HP J7988G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
NOTE: This procedure resets all TCP/IP parameters, but only affects the TCP/IP subsystem. Parameters for other subsystems such as IPX/SPX or AppleTalk are not affected. To reset all parameters to factory default values, refer to Troubleshooting the HP Jetdirect Print Server on page 117. Moving to Another Network (IPv4) When moving an HP Jetdirect print server that is configured with an IP address to a new network, make sure that the IP address does not conflict with addresses on the new network. You may change the IP address of the print server to one that can be used on the new network, or erase the current IP address and configure another address after it is installed on the new network. See Troubleshooting the HP Jetdirect Print Server on page 117 for instructions to reset the print server to factory default settings. If the current BOOTP server is not reachable, you may need to locate a different BOOTP server and configure the printer to this server. If the print server was configured using BOOTP, DHCP or RARP, edit the appropriate system files with updated settings. If the IP address was manually set (for example, from the printer control panel or Telnet), reconfigure IP parameters as described in this chapter. Using the Embedded Web Server You can use the embedded Web server on the HP Jetdirect print server to configure or view IPv4 and IPv6 parameters. For more information, refer to Embedded Web Server (V.36.xx) on page 61. Using the Printer Control Panel When supported by the printer, HP Jetdirect EIO or embedded print servers provide a configuration menu that can be accessed from the printer's control panel. Using this menu, you can enable or disable network protocols and set basic network parameters. NOTE: For instructions on using the control panel for your printer, refer to your printer documentation. Depending on the HP Jetdirect print server and printer, configuration of selected IPv4/IPv6 and IPsec networking parameters through the control panel is supported. When accessing the HP Jetdirect menu from the printer's control panel, some TCP/IP network configuration parameters that you can set include the following (see HP Jetdirect Control Panel Menus (V.36.xx) on page 169 for additional parameters): ● IP host name ● TCP/IPv4 settings ● TCP/IPv6 settings ● Other network protocols (IPX/SPX, AppleTalk, DLC/LLC) ● Security settings ● Link configuration settings ENWW Using the Embedded Web Server 59