HP LaserJet 4100 Service Manual - Page 550
Replace A Dimm Or Eio, Xx Printer Error, Cycle Power To, Continue
View all HP LaserJet 4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 550 highlights
Table 37. Printer messages (continued) Control panel message Explanation Recommended action 49.XX PRINTER ERROR A firmware error occurred. 1. Press CANCEL JOB to clear the alternates with print job from the printer memory. CYCLE POWER TO 2. Turn the printer off, and then CONTINUE turn the printer on. 3. Try printing a job from a different software application. If the job prints, go back to the first application and try printing a different file. (If the message only appears with a certain software application or print job, contact the software vendor for assistance.) 4. If the message persists with different software applications and print jobs, disconnect all cables to the printer that connect it to the network or printer. 5. Turn the printer off. 6. Remove all memory DIMMs or third-party DIMMs from the printer. (Do not remove the firmware DIMM in the lowest DIMM slot.) 7. Remove all EIO devices from the printer. 8. Turn the printer on. 9. If the error no longer exists, install each DIMM and EIO device one at a time, making sure to turn the printer off and back on as you install each device. 10. Replace a DIMM or EIO device if you determine that it causes the error. 11. Remember to reconnect all cables that connect the printer to the network or computer. 12. If the error persists, replace the firmware DIMM. 13. Replace the formatter. EN Chapter 7 Troubleshooting 211