HP LaserJet Pro 100 Service Manual - Page 84
CAUTION, supply is still connected to the product by three internal connectors.
View all HP LaserJet Pro 100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
6. Place the product rear-side up, and then remove four screws (callout 1). Figure 1-86 Remove the low-voltage power supply assembly (6 of 9) 1 7. Remove three screws (callout 1), disconnect one connector (callout 2) and separate the lowvoltage power supply assembly (callout 3) from the product. CAUTION: Do not attempt to completely remove the low-voltage power supply. The power supply is still connected to the product by three internal connectors. Figure 1-87 Remove the low voltage power supply assembly (7 of 9) 2 3 1 66 Chapter 1 Removal and replacement ENWW
6.
Place the product rear-side up, and then remove four screws (callout 1).
Figure 1-86
Remove the low-voltage power supply assembly (6 of 9)
1
7.
Remove three screws (callout 1), disconnect one connector (callout 2) and separate the low-
voltage power supply assembly (callout 3) from the product.
CAUTION:
Do not attempt to completely remove the low-voltage power supply. The power
supply is still connected to the product by three internal connectors.
Figure 1-87
Remove the low voltage power supply assembly (7 of 9)
1
2
3
66
Chapter 1
Removal and replacement
ENWW