HP ML530 ProLiant ML530 Generation 2 Memory Installation Guide - Page 15
Quick Start Memory Configuration, Advanced Options, POST Speed Up, Disable, System Options
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Memory Table 1-1: Quick Start DIMM Installation Guidelines continued Advanced ECC (Standard) Memory Online Spare Memory Single-Board Mirrored Memory Bank D must always be populated. Banks A and C must always be populated. Bank D is the online spare bank. Bank C mirrors bank A. Bank D mirrors bank B. Quick Start Memory Configuration If you plan to use online spare memory or single-board mirrored memory, you must configure your desired memory mode through RBSU. HP also recommends testing new DIMMs. To test DIMMs and configure memory: 1. Power on the server. 2. Press the F9 key to enter RBSU. 3. Select Advanced Options. 4. Change POST Speed Up to Disable. 5. Press any key to return to the RBSU main menu. 6. Select System Options. 7. Select Advanced Memory Protection. 8. Select the desired memory mode. 9. Press the ESC key twice to go back to the RBSU main menu. 10. Press the F10 key to exit RBSU. The server reboots and tests all memory in the system. 11. Once the memory has been tested, re-enable POST Speed Up for faster system boot, if desired. IMPORTANT: To reconfigure the memory mode after initial setup, you must reboot the system and enter RBSU. HP ProLiant ML530 Generation 2 Server Memory Installation Guide 1-5