HP ML530 ProLiant ML530 Generation 2 Memory Installation Guide - Page 30
Installing a DIMM, Align the keyed portion of the bottom edge of the DIMM with the tab in
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Memory Installing a DIMM To install a DIMM: 1. Remove the memory board. See "Removing a Memory Board" in this chapter. 2. Observe all DIMM installation requirements for your desired memory mode. See the "DIMM Installation Requirement" section in this chapter for each mode. IMPORTANT: Follow all DIMM configuration requirements carefully. If the DIMMs are not configured properly, you receive an error message during POST and the DIMM LEDs blink amber. 3. Align the keyed portion of the bottom edge of the DIMM with the tab in the DIMM slot. 4. Press the DIMM firmly into the slot (1) and push the latches into place (2). Figure 1-5: Installing and latching a DIMM IMPORTANT: The bottom edge of the DIMM is designed so that it fits into the DIMM slot only one way. 1-20 HP ProLiant ML530 Generation 2 Server Memory Installation Guide