HP ML530 ProLiant ML530 Generation 2 Memory Installation Guide - Page 26
Memory Configuration, Advanced Options., POST Speed Up, Disable., System Options.
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Memory Memory Configuration Configuring your server's memory system requires configuring both hardware and software. To configure your memory: 1. Remove the memory board. See "Removing a Memory Board" in this chapter. 2. Install the required DIMMs based on your desired memory mode. Be sure to follow all DIMM installation requirements. See the "DIMM Installation Requirement" section in this chapter for each mode. 3. Install the memory board. See "Installing a Memory Board" in this chapter. 4. Test the DIMMs and configure the memory mode through RBSU: a. Power on the server. b. Press the F9 key to enter RBSU. c. Select Advanced Options. d. Change POST Speed Up to Disable. e. Press any key to return to the RBSU main menu. f. Select System Options. g. Select Advanced Memory Protection. h. Select the desired memory mode. i. Press the ESC key twice to go back to the RBSU main menu. j. Press the F10 key to exit RBSU. The server reboots and tests all memory in the system. k. Once the memory has been tested, re-enable POST Speed Up for faster system boot, if desired. IMPORTANT: To reconfigure the memory mode after initial setup, you must reboot the system and enter RBSU. 1-16 HP ProLiant ML530 Generation 2 Server Memory Installation Guide