HP PageWide 377 OfficeJet Pro X and PageWide 300 400 500 series - Shipping Ins - Page 3

White Paper b. Affix a piece of tape on the shipping restraint so that a portion of the tape is exposed and clearly visible after closing the small interior door and the main ink supply door (as shown in Figure 1 above). This will ensure that the person installing the unit after shipment removes the shipping restraint prior to start-up. If the device is powered-on with the shipping restraint in place, it will cause the device to assert and/or damage the unit. NOTE: Be sure that the print bar is in a lifted-state and that the shipping restraint is installed in the "garage" of the print bar, not in the space above a print bar that is in a lowered position. The green shipping restraint should be installed in the black plastic chamber of a lifted print bar (as shown in Figure 2); it should not be installed if sheet metal is visible in the chamber (shown in Figure 3). Install the restraint in the black plastic chamber of a lifted print bar Do not install the restraint in the space above a lowered print bar Figure 2 Figure 3 c. Remove the ink supplies, if installed, and insert the large orange shipping cap in the space where the ink supplies are normally installed (shown in Figure 4 below). Figure 4 Shipping Instructions 3