HP Pavilion 11-n100 Pavilion 11 x360 PC Maintenance and Service Guide - Page 41

Disconnect the USB/audio board cable from the system board by lifting the ZIF connector, bottom cover.

Get HP Pavilion 11-n100 PDF manuals and user guides View all HP Pavilion 11-n100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

5. Separate the bottom cover from the computer by lifting up at the seam near the display hinges (1), and then lift the cover up and off the computer (2) far enough to access the USB/audio board connector on the system board. NOTE: When you lift the bottom cover, a cable is connected from the USB/audio board (installed on the inside of the bottom cover) to the system board. Be sure not to pull the cable loose when lifting the bottom cover. 6. Disconnect the USB/audio board cable from the system board by lifting the ZIF connector (1), and then removing the USB/audio board cable from the system board connector (2). Reverse this procedure to install the bottom cover. Component replacement procedures 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
5.
Separate the bottom cover from the computer by lifting up at the seam near the display hinges
(1)
, and
then lift the cover up and off the computer
(2)
far enough to access the USB/audio board connector on
the system board.
NOTE:
When you lift the bottom cover, a cable is connected from the USB/audio board (installed on
the inside of the bottom cover) to the system board. Be sure not to pull the cable loose when lifting the
bottom cover.
6.
Disconnect the USB/audio board cable from the system board by lifting the ZIF connector
(1)
, and then
removing the USB/audio board cable from the system board connector
(2)
.
Reverse this procedure to install the bottom cover.
Component replacement procedures
33