HP Pavilion 9800 HP Pavilion Desktop PCs - PCI 56K Modem Aztech - (English) Us - Page 3

New Zealand Telecom Warnings, General - service manual

Page 3 highlights

Product warranty does not apply to damage caused by lightning, power surges or wrong voltage usage. NEW ZEALAND TELECOM WARNINGS General “The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom’s network services.” “This equipment does not fully meet Telecom’s impedance requirements. Performance limitations may occur when used in conjunction with some parts of the network. Telecom will accept no responsibility should difficulties arise in such circumstances.” “This equipment shall not be set up to make automatic calls to the Telecom ‘111’ Emergency Service.” “If a charge for local calls is unacceptable, the ‘Dial’ button should NOT be used for local calls. Only the 7-digits of the local number should be dialled from your telephone. DO NOT dial the area code digit or the ‘0’ prefix.” “This equipment may not provide for the effective hand-over of a call to another device connected to the same line.” “Important Notice Under power failure conditions, this telephone may not operate. Please ensure that a separate telephone, not dependent on local power, is available for emergency use.” “Some parameters required for compliance with Telecom’s Telepermit requirements are dependent on the equipment (PC) associated with this device. The associated equipment shall be set to operate within the following limits for compliance with Telecom’s Specification :- 1. (a) There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, and (b) The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next attempt. 2. Where automatic calls are made to different numbers, the equipment shall go on-line for a period of not less than 5 seconds between the end of one attempt and the beginning of the next attempt. 3. The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of receipt of ringing.” “All persons using this device for recording telephone conversations shall comply with New Zealand law. This requires that at least one party to the conversation is to be aware that it is being recorded. In addition, the Principles enumerated in the Privacy Act 1993 shall be complied with in respect to the nature of the personal information collected, the purpose for its collection, how it is used and what is disclosed to any other party.” 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47

3
NEW ZEALAND TELECOM WARNINGS
General
±The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item
complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom,
nor does it provide any sort of warranty.
Above all, it provides no assurance that any item will work correctly in all
respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product
is compatible with all of Telecom³s network services.²
±This equipment does not fully meet Telecom³s impedance requirements.
Performance limitations may occur when used
in conjunction with some parts of the network.
Telecom will accept no responsibility should difficulties arise in such
circumstances.²
±This equipment shall not be set up to make automatic calls to the Telecom µ111³ Emergency Service.²
±If a charge for local calls is unacceptable, the µDial³ button should NOT be used for local calls.
Only the 7-digits of the
local number should be dialled from your telephone. DO NOT dial the area code digit or the µ0³ prefix.²
±This equipment may not provide for the effective hand-over of a call to another device connected to the same line.²
±Important Notice
Under power failure conditions, this telephone may not operate. Please ensure that a separate telephone, not dependent
on local power, is available for emergency use.²
±Some parameters required for compliance with Telecom³s Telepermit requirements are dependent on the equipment
(PC) associated with this device.
The associated equipment shall be set to operate within the following limits for compliance
with Telecom³s Specification :-
1.
(a)
There shall be no more than 10 call attempts to the same number within any 30 minute period for any single
manual call initiation, and
(b)
The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt
and the beginning of the next attempt.
2.
Where automatic calls are made to different numbers, the equipment shall go on-line for a period of not less than
5 seconds between the end of one attempt and the beginning of the next attempt.
3.
The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of receipt of ringing.²
±All persons using this device for recording telephone conversations shall comply with New Zealand law.
This requires
that at least one party to the conversation is to be aware that it is being recorded.
In addition, the Principles enumerated
in the Privacy Act 1993 shall be complied with in respect to the nature of the personal information collected, the purpose
for its collection, how it is used and what is disclosed to any other party.²
Product warranty does not apply to damage caused by lightning, power surges or wrong voltage usage.