HP ProLiant 1500 ProLiant Server Troubleshooting Guide - Page 133

Error Recovery Table 5-2: System Configuration Utility Settings for Booting into Diagnostics continued Option Setting Description Dial-out string 555-1234 Enter the dial string followed by the remote computer's telephone number. Network status Enabled To allow network access to Diagnostics, set Network Status to Enabled and be sure that the Reset Boot option is set to Boot Diagnostics. NOTE: The Network Status must be set to Enabled for network access. Network controller slot Slot # Select the slot number of the network interface controller you wish to use for network access to Diagnostics. Network protocol IP/IPX To use IPX network access, set Network Protocol to IPX. When ASR-2 restarts the server to Diagnostics, it loads IPX network support. This enables remote access by NVT. To use IP network access, set Network protocol to IP. Also be sure to set Network IP address, Network IP net mask, and Network IP router address. When ASR-2 restarts the server to Diagnostics, it loads IP network support, enabling remote access by Telnet. Network host name HP_Server Enter the network name of the server. Use underscores instead of spaces within the name, for example, HP_Server. If you are using IPX network access to Diagnostics, this server name is used to advertise NVT host services. This server name is displayed in the Insight Manager server list when the system determines that it can communicate by NVT. Set this name to be the same as the server name you assign when the host operating system is running. Network controller HP For all HP standard network controllers. Network frame type ETHERNET_II Select the frame type for your network. Selections include both Ethernet and IBM Token-Ring topologies. continued 5-12 HP Servers Troubleshooting Guide