HP ProLiant 1500 ProLiant Server Troubleshooting Guide - Page 300

Index SCSI port X, Drive ID Y RIS copies within this drive do not match D-15 SCSI port X, Drive ID Y S.M.A.R.T. predictive failure errors have been detected D-16 SCSI port X, Drive ID Y was replaced on a good volume D-16 SCSI tape drive test error codes B-15 SCSI tape ID drive types test failed B-15 SCU (System Configuration Utility) accessing A-5 described A-5 Diagnostics, accessing 4-6 Inspect Utility, accessing 4-10 POST error messages C-6 search engines A-3 secondary disk controller failure C-67 secondary disk port address assignment conflict C-58 security ASR-2 5-15 maintaining 5-15 serial number, BIOS, POST error messages C-4 serial port address conflict detected C-37 serial port test failed B-9 serial port, POST error messages C-37 serial/parallel interface board, test error codes B-9 server booting problems 1-6, 1-7, 1-8, 1-9, 1-10, 1-11, 1-12, 1-13, 1-14, 2-5, 2-6, 2-7, 2-8, 2-9, 2-10, 2-11, 2-12, 2-16 changes, problem prevention 6-2 failure, backup plan 6-5 maintenance, Integration Maintenance Utility 6-3 maintenance, suggestions 6-5 management, website 4-8 naming conventions 6-5 periodic visual check 6-7 powering down 1-3 shutdown procedure 1-3 software updates, Integration Maintenance Utility 6-3, 6-4 server blade health driver 4-18 Server Feature Board is not properly cabled to the system C-30 Server Feature Board must be installed in slot 1 for proper operation C-30 Server Feature Board, POST error messages C-30 server management 4-8 64-bit systems 4-8 accessing A-5 component information, collecting 1-13 described 4-8 error messages 1-12 predictive failure alert 2-30 problem diagnosis 3-1 resources A-9 utilization rate/traffic, determining 1-17 version conflict 1-16 version control option 6-4 website A-5 server management board is in the wrong slot C-44 server response time 2-25 server setup utility BIOS Setup Utility A-6 RBSU A-5 SCU A-5 server-specific user documentation accessing 1-2, 2-37, A-2 defined xii service pack, installation problems 3-3 set configuration command issued D-16 HP Servers Troubleshooting Guide Index-25