HP ProLiant DL160 HP ProLiant DL160 Generation 5 Server Software Configuration - Page 36

Turn on the monitor., Perform the post-installation procedure.

Get HP ProLiant DL160 - G5 Server PDF manuals and user guides View all HP ProLiant DL160 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

3. Check the following conditions: a. If you have installed an expansion board, verify that the board is firmly seated in its slot and any switches or jumpers on the board are properly set. Refer to the documentation provided with the expansion board. b. All internal cabling and connections are in their proper order. c. If you have changed any switches on the system board, verify that each one is properly set. 4. Perform the post-installation procedure. 5. Turn on the monitor. 6. If the server still does not work, repeat step 2. 7. Remove all accessories, except the primary boot hard disk drive. 8. Repeat steps 4 and 5. If the server now works, replace the boards and accessories one at a time to determine which one is causing the problem. System BIOS configuration 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
System BIOS configuration 36
3.
Check the following conditions:
a.
If you have installed an expansion board, verify that the board is firmly seated in its slot and
any switches or jumpers on the board are properly set. Refer to the documentation provided
with the expansion board.
b.
All internal cabling and connections are in their proper order.
c.
If you have changed any switches on the system board, verify that each one is properly set.
4.
Perform the post-installation procedure.
5.
Turn on the monitor.
6.
If the server still does not work, repeat step 2.
7.
Remove all accessories, except the primary boot hard disk drive.
8.
Repeat steps 4 and 5.
If the server now works, replace the boards and accessories one at a time to determine which
one is causing the problem.