HP Q3722A HP LaserJet 9040/9050 - User Guide - Page 123

ENWW Message Explanation or recommended action INSERT OR CLOSE TRAY xx For help press The specified tray must be inserted or closed for printing to continue. INSTALL CARTRIDGE For help press The print cartridge has been removed or has been installed incorrectly. It must be replaced or reinstalled correctly for printing to continue. Insufficient memory to load Fonts/Data For help press alternates with [DEVICE] To continue press The printer does not have enough memory to load the data (for example, fonts or macros) from the location specified. Touch OK to continue without this information. If the message persists, add more memory. LOAD TRAY XX [TYPE] [SIZE] To use another tray press . alternates with LOAD TRAY XX [TYPE] [SIZE] For help press A job is sent that requires a specific type and size that is not available. Load the requested paper into optional Tray 1. Press to use a type and size that is available in another tray. LOAD TRAY XX [TYPE] [SIZE] For help press The tray is empty or is configured for a different size of paper than the size that was requested. MANUALLY FEED [TYPE] [SIZE] For help press alternates with To use another tray press . Load the requested paper into optional Tray 1. To override the message, press tray. if the desired paper is available in another Press to use a type and size that is available in another tray. No job to cancel The STOP button was pressed, but there is no active job or buffered data to cancel. The message appears for approximately two seconds before the printer returns to the READY state. NON-HP SUPPLY INSTALLED alternates with Economode disabled The printer has detected that the supply is not a genuine HP cartridge, and the message appears for approximately 30 seconds before the printer is returned to the READY state. If you think you purchased an HP print cartridge, go to www.hp.com/go/anticounterfeit. Any printer repair that is required as a result of using a non-HP print cartridge is not covered under the printer warranty. ORDER CARTRIDGE LESS THAN XXXX PAGES For help press The print cartridge is low and the CARTRIDGE LOW setting in the SYSTEM SETUP submenu is set to CONTINUE. Approximately 2 weeks of typical printing capacity remains in the cartridge. This offers sufficient time to order a new cartridge. Resolving control-panel messages 121