HP Q7518A HP Color LaserJet 4730mfp - User Guide - Page 280
Error executing Digital Send job. Job, Front Side Optical System Error
View all HP Q7518A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 280 highlights
Control panel message EIO X disk initializing EIO X disk spinning up Error executing Digital Send job. Job failed. Event Log Empty FLASH DEVICE FAILURE To clear touch "OK". alternates with Ready FLASH FILE SYSTEM IS FULL To clear touch "OK". alternates with Ready FLASH IS WRITE PROTECTED To clear touch "OK". alternates with Ready Front Side Optical System Error Genuine HP supplies installed HP Digital Sending: Delivery Error Incorrect PIN Description The EIO disk device in slot X is initializing. Recommended action No action necessary. The EIO disk device in slot X is spinning up No action necessary. its platter. A digital send job has failed and cannot be Try to send the job again. delivered. SHOW EVENT LOG was selected from the No action necessary. control panel, and the event log is empty. A device failure has occurred on the specified 1. drive. Printing can continue for jobs that do not require the Flash DIMM. 2. To clear the message, touch OK. If the message persists, remove and reinstall the EIO disk drive. 3. Turn the MFP back on. 4. If the message still persists, replace the Flash DIMM. The MFP received a PJL file system 1. command that attempted to store something on the file system but was unsuccessful because the file system is full. 2. Use HP Web Jetadmin software to delete files from the Flash Memory and try again. To clear the message, touch OK. 3. If the message persists, turn the MFP off then on. The file system device is protected and no new files can be written to it. 1. To enable writing to the Flash Memory, turn off write protection, using HP Web Jetadmin. 2. To clear the message, touch OK. 3. If the message persists, turn the MFP off then on. The scanner has experienced an error. To temporarily clear the message so you can send a fax or send to e-mail, touch IGNORE. If this message persists, contact an HP-authorized service or support provider. See the HP support flyer, or go to http://www.hp.com/suppport/clj4730mfp. A new HP cartridge has been installed. The MFP returns to the Ready state after approximately 10 seconds. No action necessary. A digital send job has failed and cannot be Try to send the job again. delivered. The wrong PIN was entered. After three incorrect PIN entries, the MFP will return to Ready. Re-enter PIN correctly. 260 Chapter 12 Solving problems ENWW