Home » HP Manuals » Storage Devices » HP StorageWorks 16-EL » Manual Viewer

HP StorageWorks 16-EL HP StorageWorks SAN Switch Rack Mount Kit Installation I - Page 12

loosely as shown

View all HP StorageWorks 16-EL manuals

Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

4. Assemble the outer rails by completing the following steps: a. Attach the left outer rail and the right outer rails to the rear mounting brackets using (2) 1/4-20 hex nuts with captive star lock washers attached loosely as shown in Figure 4. Don't tighten them. The nuts will be tightened later in step 8. Figure 4: Installing the outer rails (HP 9000 Series or comparable EIA rack) 12 SAN Switch Rack Mount Kit Installation Instructions

Section	Page
About this Document	3
Intended Audience	3
Related Documentation	3
Rack Stability	4
Installation and Safety Guidelines	5
Selecting an Operating Location	5
Cooling Requirements	5
Power Requirements	6
Rack Mount Checklist	6
Installing the Switch in a Rack Using the SAN Switch Rack Mount Kit	8
Figure 1: SAN Switch 2/16 rack-mounted switch	8
Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA rack)	10
Figure 3: Installing the rear mounting brackets (HP System/e rack-left rear upright)	11
Figure 4: Installing the outer rails (HP 9000 Series or comparable EIA rack)	12
Figure 5: Assembling the outer rails (HP 9000 Series or comparable EIA rack)	13
Figure 6: Assembling the outer rails (HP System/e rack)	14
Table 1: Number of screws required to assemble the inner rails	14
Figure 7: Assembling the inner rails	16
Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum	17
Figure 9: Installing the switch into a rack (HP 9000 Series or comparable EIA rack)	18