HP StorageWorks 2/16V HP StorageWorks Fabric OS 5.3.2b release notes (5697-007 - Page 16

Fabric OS 5.3.1b fixes, HP StorageWorks Fabric OS 5.2.3 release notes

Get HP StorageWorks 2/16V - SAN Switch PDF manuals and user guides View all HP StorageWorks 2/16V manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Only 1 FL port FLOGI is successful and second FL port FLOGI is disabled in a time interval. Even though FL port will be re-enabled after the short time Fixed in Fabric OS 5.3.1a. interval, 3rd party failover application may fail. When the proxy device projected to the backbone had a translate domain of greater than 0x20, router is not translating the ACC for a REC properly. Fixed in Fabric OS 5.3.1a. Customer observes traffic interrupted and tape device fail. When there is an application request GPPN on a device connected to multiple switches, customer might see continuous rtwr message on a pair of switches and directed at each other from msd: [RTWR-1003],,, INFO, , msd0: RTWR retry 48 to domain 152, iu_data 1000000 RTWR Maxretries exhausted: 0x30, 0x8, 0x65, 0x0, 0x41d on multipath switches. Potential for switch panic when memory is exhausted. Fixed in Fabric OS 5.3.1a. Fabric OS 5.3.1b fixes Table 5 lists defects closed in the Fabric OS 5.3.1b firmware release. Table 5 Fabric OS 5.3.1b closed defects Closed defect summary An ipfilter --transabort command running in one Telnet session can be aborted from another Telnet session. Problems within an IP network could cause a switch running Fabric OS 5.3.x to panic. Solution Fixed in Fabric OS 5.3.1b. Fixed in Fabric OS 5.3.1b. Workaround: Disable the clients trying to access evmd. On the HP StorageWorks 2/128, when a specific 3rd party RAID system firmware is upgraded, the autonegotiate sequence fails, and the route to this device is lost. Fixed in Fabric OS 5.3.1b. Workaround: Run portdisable and portenable to reset the port. Switch did not send message to RASLog for errdump when status changed from healthy to marginal due to compact flash memory issue. Fixed in Fabric OS 5.3.1b. IMPORTANT: All Fabric OS 5.2.3 closed defects as listed in the HP StorageWorks Fabric OS 5.2.3 release notes have been rolled into Fabric OS 5.3.2 firmware. However, note that these 5.2.3 closed defects have not been resolved in any 5.3.x release prior to 5.3.1 (specifically 5.3.0, 5.3.0a, 5.3.0b, 5.3.0c or 5.3.0d). Fabric OS 5.3.2 fixes Table 6 lists defects closed in the Fabric OS 5.3.2 firmware release. Table 6 Fabric OS 5.3.2 closed defects Closed defect summary Solution 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Fixed in Fabric OS 5.3.1a.
Only 1 FL port FLOGI is successful and second FL port FLOGI is disabled
in a time interval. Even though FL port will be re-enabled after the short time
interval, 3rd party failover application may fail.
Fixed in Fabric OS 5.3.1a.
When the proxy device projected to the backbone had a translate domain
of greater than 0x20, router is not translating the ACC for a REC properly.
Customer observes traffic interrupted and tape device fail.
Fixed in Fabric OS 5.3.1a.
When there is an application request GPPN on a device connected to
multiple switches, customer might see continuous rtwr message on a pair
of switches and directed at each other from msd:
[RTWR-1003],,, INFO,
, msd0: RTWR retry 48 to domain 152, iu_data 1000000
RTWR Maxretries exhausted: 0x30, 0x8, 0x65, 0x0, 0x41d
on multipath switches
. Potential for switch panic when memory is
exhausted.
Fabric OS 5.3.1b fixes
Table 5
lists defects closed in the Fabric OS 5.3.1b firmware release.
Table 5 Fabric OS 5.3.1b closed defects
Solution
Closed defect summary
Fixed in Fabric OS 5.3.1b.
An
ipfilter --transabort
command running in one Telnet session
can be aborted from another Telnet session.
Fixed in Fabric OS 5.3.1b.
Workaround:
Disable the clients
trying to access evmd.
Problems within an IP network could cause a switch running Fabric OS
5.3.x to panic.
Fixed in Fabric OS 5.3.1b.
Workaround:
Run
portdisable
and
portenable
to reset the port.
On the HP StorageWorks 2/128, when a specific 3rd party RAID system
firmware is upgraded, the autonegotiate sequence fails, and the route to
this device is lost.
Fixed in Fabric OS 5.3.1b.
Switch did not send message to RASLog for
errdump
when status changed
from
healthy
to
marginal
due to compact flash memory issue.
IMPORTANT:
All Fabric OS 5.2.3 closed defects as listed in the
HP StorageWorks Fabric OS 5.2.3 release notes
have been rolled into Fabric OS 5.3.2 firmware. However, note that these 5.2.3 closed defects have
not been resolved in any 5.3.x release prior to 5.3.1 (specifically 5.3.0, 5.3.0a, 5.3.0b, 5.3.0c or
5.3.0d).
Fabric OS 5.3.2 fixes
Table 6
lists defects closed in the Fabric OS 5.3.2 firmware release.
Table 6 Fabric OS 5.3.2 closed defects
Solution
Closed defect summary
16