HP T5700 Terminal Emulation User's Guide (XPe) - Page 221

Session Configuration Initialization Commands Start-up Command Group To Action Registry Entry: None Command Line: -Nname Default Setting: Default You can specify more than one set of start-up commands in the registry. This enables you to configure each instance of the emulator differently. Each set of commands other than the default set must have the following heading in the registry under HKLM\Software\Pericom\: Startup,name where name can be any unique identifying name. You can specify which set of startup commands the emulator is to use by including the following on the command line for loading the emulator, where name is substituted with the actual name of the start-up group required: -Nname If this command is not present then the emulator will use the start-up commands under the Startup,Default heading. Connection Template To Use Registry Entry: None Command Line: -SE"description" Default Setting: Untitled This command enables you to override the default connection template used when the emulator is loaded, as specified in the Open Session dialog box. The description must exactly match the description assigned to a connection template already saved using the Save Session As dialog box and must be enclosed by double-quotes. Disable Bell Registry Entry: Bell = "off" Command Line: -BE Default Setting: Enabled These commands enable you to turn off the terminal bell. 15-7