HP T5735 Hardware Reference Guide: HP Compaq t5730/t5735 Thin Clients - Page 20
Removing and Replacing the Side Access Panel and Metal Side Cover
UPC - 883585606238
View all HP T5735 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Removing and Replacing the Side Access Panel and Metal Side Cover Removing the Side Access Panel and Metal Side Cover WARNING! Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet. To remove the access panel: 1. Remove the secure compartment cover (1). For more information, see Removing the Secure USB Compartment Cover on page 12. 2. Remove the access panel screw in the secure USB compartment that secures the access panel to the chassis (2). 3. Slide the access panel about 6.35 mm (1/4 inch) toward the rear of the unit (3), and then lift the access panel up and off the unit (4). Figure 2-3 Removing the side access panel To remove the metal side cover: NOTE: Do not remove the metal side cover when installing a PCI Expansion Module. You must remove the metal side cover to access internal components such as the battery or the memory. 1. Remove the four screws that secure the metal side cover to the chassis (1). 14 Chapter 2 Hardware Changes