HP T5735 Hardware Reference Guide: HP Compaq t5730/t5735 Thin Clients - Page 23

Installing the USB Device, Removing and Replacing the Battery, WARNING

Get HP T5735 - Compaq Thin Client PDF manuals and user guides
UPC - 883585606238
View all HP T5735 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Installing the USB Device Before beginning the replacement process, review General Hardware Installation Sequence on page 10 for procedures you should follow before and after installing or replacing hardware. ▲ Insert the USB device into the USB port in the secure USB compartment. See the following illustration for the location of the ports in the secure USB compartment. Figure 2-7 USB ports in the secure USB compartment Removing and Replacing the Battery Before beginning the replacement process, review General Hardware Installation Sequence on page 10 for procedures you should follow before and after installing or replacing hardware. WARNING! Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet. To remove and replace the battery: 1. Locate the battery on the system board. Installing Thin Client Options 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Installing the USB Device
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
10
for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-7
USB ports in the secure USB compartment
Removing and Replacing the Battery
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
10
for procedures you should follow before and after installing or replacing hardware.
WARNING!
Before removing the side access panel, ensure that the thin client is turned off and the
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
Installing Thin Client Options
17