HP Workstation xw4100 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 62

Adaptec SCSI RAID Software Reference Guide container create mstripe To create a multilevel stripe set from equally sized arrays, use the container create mstripe command. The top level of a multilevel stripe array can only be a stripe set. You can create the following types of multilevel stripe set: ■ Stripe set of mirror sets ■ Stripe set of volume sets ■ Stripe set of stripe sets ■ Stripe set of RAID-5 sets (a RAID-50 set) Notes When creating a multilevel array of stripe sets on a NetWare server, you specify the container IDs (as described in the Parameters section) for the arrays from which you want to create the multilevel stripe set. If NetWare is using any of these arrays, an appropriate message displays. This message indicates that one or more of the arrays you specified is in use by NetWare. The message directs you to remove any NetWare volumes and partitions from these arrays. You can then create a multilevel array of stripe sets on a NetWare server. After you create a multilevel array of stripe sets you can run the list devices command on the NetWare console to verify its creation and then create the necessary NetWare disk partitions and volumes. For information on how to create partitions and volumes, see the appropriate NetWare documentation. Syntax container create mstripe [/stripe_size{=integer}] [/label{=string}]{container} [{container}...] 5-14