HP mv5150 HP MV2120, MV5020, MV5140, MV5150 Media Vault - User's Guide - Page 155

If you wish to restore the system drive, you must use the PC Restore Disc. A system drive cannot be restored from the Windows operating system because it would have to write over itself. About restoring a drive backup Note: When restoring a disk drive, any content that exists on the target hard drive or drive partition will be erased. • Restored NTFS partitions cause the Windows chkdsk utility to run when the system is rebooted. This utility creates and displays a status report for a disk based on the file system. Windows 2000 SP4 or Windows XP will run the verification process and then restart. The restored drive should be fully operational after the computer restarts. • You cannot select a partition that is smaller than the amount of data on the original partition. However, you may select a larger partition. In some cases, you may need to select a target partition that is the same size as the original partition. • When you select a drive to restore, you must pay attention to the compatibility of the file systems between the source backup and the target drive. The following table lists all compatible combinations of source and target file systems and the resulting partition format. Table 4: Compatible Combinations Source Partition Target Partition NTFS NTFS NTFS FAT 16 NTFS FAT 32 Any other combinations are not supported. Resulting Partition NTFS NTFS NTFS To restore a drive backup, follow these steps: 1 At the computer, click Start, All Programs, HP Media Vault, and then Control Center. 2 On the Backup tab, click Back up Entire Hard Drive. 11-