Hitachi 46W500 Owners Guide - Page 15
Connecting External Audio Devices, Connecting External Video Sources - manual
View all Hitachi 46W500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
CONNECTING EXTERNAL AUDIO DEVICES To control the audio level of an external audio amplifier with the remote control, connect the system as shown below. REAR PANEL OF TELEVISION ANT A TO CONVERTER ANT B INPUT 1 INPUT 2 PR PB Y R (MONO)/L AUDIO PR PB Y/VIDEO R (MONO)/L AUDIO DVI-HDTV INPUT 3 R (MONO)/L VIDEO S-VIDEO AUDIO TO HI-FI L R INPUT 4 R (MONO)/L VIDEO MONITOR OUT R L AUDIO VIDEO S-VIDEO S-VIDEO OPTICAL OUT Digital Audio LR INPUT OR OPTICAL INPUT Stereo System Amplifier Stereo System Amplifier NOTE: 1. The Optical Out (Digital Audio) is only available in DVD mode. 2. To prevent damage to the speaker and distorted sound, set the volume control of the audio amplifier lower and adjust the sound using the remote control of the TV set. 3. The Optical Out (Digital Audio) provides a fixed digital audio output to your external component such as an AV receiver with optical input capability. The audio level can only be controlled through the volume control of the external audio amplifier. 4. See page 43 for other Internal Speakers settings. CONNECTING EXTERNAL VIDEO SOURCES The exact arrangement you use to connect the VCR, camcorder, laserdisc player, DVD player, or HDTV Set Top Box to your TV set is dependent on the model and features of each component. Check the owner's manual of each component for the location of video and audio inputs and outputs. The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your particular assortment of components and features. For best performance, video and audio cables should be made from coaxial shielded wire. Before Operating External Video Source The input mode is changed every time the VID1~VID5 button is pressed as shown below. Connect an external source to the INPUT terminal, then press the VID1~VID5 button as necessary to view the input source (see page 26). INPUT MODE SELECTION ORDER (ANTENNA) (INPUT) Ant A VID1 YPBPR:1 VID1 ANT NOTE: When the TV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the back panel of the TV (i.e., VCR/laserdisc player, etc. is not connected or the video device is OFF), the set will appear to be OFF. 15