Hitachi B13FI Instruction Manual - Page 18

Maintenance

Get Hitachi B13FI - 10 Inch Drill Press PDF manuals and user guides
UPC - 717709012035
View all Hitachi B13FI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

English MAINTENANCE MAINTAINING YOUR DRILL PRESS WARNING For our own safety, turn the switch OFF and remove the plug from the power source outlet before maintaining or lubricating your drill press. Frequently blow out, using an air compressor or dust vacuum, any dust that accumulates inside the motor. A coat of paste wax applied to the table and column will help to keep the surface clean & help avoid rust. To avoid shock or fire hazard, if the power cord is worn or cut on any way, have it replaced immediately. LUBRICATION All of the drill press ball bearings are packed with grease at the factory. They require no further lubrication. Periodically lubricate the gear and rack for the table elevation. Lower spindle to maximum depth and oil moderately once every three months. BATTERIES Check the laser batteries regularly to avoid deterioration. Remove the batteries if you will not be using the laser for an extended time. - 18 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
English
– 18 –
MAINTAINING YOUR DRILL PRESS
For our own safety, turn the switch OFF and remove the plug
from the power source outlet before maintaining or lubricating
your drill press.
Frequently blow out, using an air compressor or dust vacuum,
any dust that accumulates inside the motor. A coat of paste
wax applied to the table and column will help to keep the
surface clean & help avoid rust.
To avoid shock or fire hazard, if the power cord is worn
or cut on any way, have it replaced immediately.
LUBRICATION
All of the drill press ball bearings are packed with grease at
the factory. They require no further lubrication. Periodically
lubricate the gear and rack for the table elevation. Lower
spindle to maximum depth and oil moderately once every
three months.
BATTERIES
Check the laser batteries regularly to avoid deterioration.
Remove the batteries if you will not be using the laser for an
extended time.
WARNING
MAINTENANCE