HoMedics AR-NC02 Downloadable Instruction Book - Page 5

Control Panel QUIET TURBO Fan Speed On/Off CLEAN FILTER 1hr 4hr 8hr 12hr Clean Filter Timer Key NOTE: Unit will not operate unless Nano-Coil, pre-filter and grill are properly installed. Operating Instructions 1. On/Off and Speed Settings 1. To turn the air cleaner on, press the ON/OFF button. When the air cleaner is on, the LED light will be lit and the air cleaner will start to operate on LOW speed. 2. There are four speed settings: Quiet (low) (medium) TURBO. Quiet mode is whisper quiet - below normal room noise - and is recommended particularly for night use and uninterrupted sleep. TURBO mode gives a cleaning power boost. When the fan is set at TURBO, it will run for 30 minutes and then return to (low) speed. 3. To turn the air cleaner OFF, simply press the ON/OFF again. 2. Timer Settings There are four possible timer settings: 1 (one) hour, 4 (four) hours, 8 (eight) hours, and 12 (twelve) hours. To activate the timer, press the on the control panel. Each time it is pressed, it will advance to the next timer setting. The timer LED will be illuminated while the timer function is on. Cycle through 1, 4, 8, 12, then off to operate the unit without the timer feature. 8 Filter Cleaning and Maintenance Make sure the air cleaner is turned off and unplugged from the outlet before cleaning. Check the filters every 30 days to see if they need cleaning. If you use your air cleaner daily, we recommend checking the filters more frequently. Nano-Coil Filter 1. Open the rear grill by gently pushing the release tabs toward the outside of the unit. See Fig. 7 Fig. 7 2. Pull the grill away from the body until the tabs at the bottom of the grill plate easily slide away from the unit. See Fig. 8 & 9 Fig. 8 Fig. 9 9