HoMedics AR-NC02 Downloadable Instruction Book - Page 6

3. Remove the Nano-Coil filter from the unit by grasping the center handle and pulling out from the center hub. See Fig. 10 Pre-Filter 1. Open the rear grill by gently pushing the release tabs toward the outside of the unit. See Fig. 14 Fig. 10 4. Use the brush attachment with your vacuum cleaner. Run the attachment along both sides of the Nano-Coil filter, taking care not to dislodge the combs. See Fig. 11 Fig. 11 5. Replace the Nano-Coil filter. Make sure to align the center of the filter handle with the center hub. Filter handle should be vertical. Be sure the post on the center hub comes through the hole on the filter's handle. See Fig. 10 6. Place the tabs at the bottom of the TABS TABS grill plate into the base of the unit. See Fig. 12 Fig. 14 2. Pull the grill away from the body until the tabs at the bottom of the grill plate easily slide away from the unit. See Fig. 15 & 16 Fig. 15 Fig. 12 Fig. 13 7. Hold engaged bottom of the grill plate in place and push the top of the grill plate back toward the unit until the release tabs at the top of the grill click back into place. See Fig. 13 DO NOT USE WATER OR ANY HOUSEHOLD CLEANERS OR DETERGENTS TO CLEAN THE NANO-COIL FILTER OR PRE-FILTER 10 Fig. 16 11