Honeywell HW2000i Owners Manual - Page 18

Starting Generator Starting Generator Starting Generator WARNING Before starting generator, be sure to thoroughly read all information provided in this Owner's Manual. NOTICE It is very important to maintain the proper level of engine oil to keep the engine in good running condition. • Check engine oil level prior to each use. IMPORTANT! BEFORE STARTING GENERATOR, FILL WITH ENGINE OIL. Starting generator with appliances connected can cause permanent damage to appliances. • NEVER start generator with electrical appliances plugged in and turned on. • Do not move the generator while it is running. 1. Fill the fuel tank and check oil is to appropriate level. NOTE: The generator starts more easily with a full fuel tank. 2. Place the generator outside on a flat surface free of debris to prevent blocking the air intake vents in the bottom of the generator. 4. Move the choke to the ON position. NOTE: Place the choke in the OFF position when the HW1000i has a warm engine. 5. Set the efficiency mode switch to the OFF position. FIGURE 7: Efficiency Mode Switch 6. Turn the fuel valve to the ON position. OFF FUEL ON p/n 101592A ON FIGURE 8: Fuel Valve - ON position 7. Press the engine control switch to the RUN position. FIGURE 9: Engine Control Switch 8. HW1000i Model Only: Turn the fuel cap vent to the ON position. ON OFF FIGURE 6: Air Intake - DO NOT BLOCK NOTICE Blocking the air flow may cause damage to the generator. 3. Connect a ground wire to the generator (see "Ground- ing the Generator" on page 6). FIGURE 10: Fuel Cap Vent - ON position 12 www.honeywellgenerators.com HW1000i / HW2000i Inverter Generator Owner's Manual