Honeywell HW2000i Owners Manual - Page 19
HW2000i Model Only, Starting Generator, NOTICE
UPC - 894190002193
View all Honeywell HW2000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
HW2000i Model Only: Depress the primer bulb 3 times to supply fuel to start the engine. Starting Generator Starting Generator 12. After starting, confirm the output ready indicator light is green and stays on. FIGURE 11: Prime Engine NOTE: INITIAL START: Depress the primer bulb 30-50 times to prime the fuel lines. NOTE: If the generator has a low fuel tank or has been run to empty before being refilled, the primer bulb may need to be depressed 30-50 times to prime the fuel lines. 9. While securing the generator with one hand, grip the recoil starter handle and pull slowly until you feel slight resistance. (HW2000i model illustrated) FIGURE 13: Output Ready Indicator Light (HW1000i model) 13. Allow the engine to run continuously and warm up before connecting any appliance. NOTICE If the engine stops and will not restart, check the engine oil level before troubleshooting in other areas. FIGURE 12: Recoil Starter Handle 10. Apply 1 to 4 swift pulls to start the engine, carefully returning the recoil starter handle to the original position. NOTICE To prevent damage to the generator, do not allow the recoil starter handle to snap back against the engine. 11. After the engine starts, let run for 2-5 seconds and then slowly move the choke to the OFF position. HW1000i / HW2000i Inverter Generator Owner's Manual www.honeywellgenerators.com 13