Hoover C1703900 Manual - Page 14
On-off Switch, Cord Clip, Handle Positions, Transporting Cleaner, Carry Handle, Embedded Dirtfinder
UPC - 073502019429
View all Hoover C1703900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ON-OFF switch Plug cord into electrical outlet. To turn cleaner ON, push switch (A) toward front of cleaner. To turn cleaner OFF, push switch toward back of cleaner. 2.2 A Handle positions The handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating position for general operation on carpet and floors; low for reaching under low furniture. Step on handle release lever to lower handle. 2.4 Carry handle The cleaner can also be moved by using the carry handle. 2.6 Cord clip To help keep the cord out of the way while vacuuming, position cord down into cord clip (B) located between top cord hook and handle. 2.3 B Transporting cleaner To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels and push forward. 2.5 Embedded DirtFINDER™ (Available on select models only) 2.7 With red and green lights (A), the 'DirtFINDER' system alerts the user to areas of carpet that may need more AB cleaning attention. It is able to sense when larger amounts of dirt particles, especially embedded dirt, are removed. To let you know that the DirtFINDER™ feature is ready, the red light will come on when the cleaner is first turned on. After a few seconds, the red light will go off and the green light will come on. Cleaning may then begin. The green light will remain on throughout cleaning except when the detector senses that a larger amount of dirt is being picked up; then the red light will come on. When the red light is on, you should take additional cleaning strokes in the area until it changes to green. • The red light may seldom come on during cleaning. This means that your cleaner is picking up primarily fine surface dust and lint which the system may not detect, or that the carpet is generally clean. To increase the feature's sensitivity to dirt, set the switch (B) to the "Hi" position. • At other times, the red light may stay on for a considerable amount of time. This means that the carpet contains a high level of dirt which is being removed by the cleaner. To decrease the feature's sensitivity to dirt, set the switch to the "Reg" (Regular) position. 7