Hoover C1703900 Manual - Page 26
Caution
UPC - 073502019429
View all Hoover C1703900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
4.12 With lettering on outside of belt and positioned as shown in box on (D), slide new belt over motor pulley (B). 4.13 Insert agitator through belt and place belt in belt guide (C) on agitator. Should the agitator shield (D) become dislodged while replacing the belt or the agitator, reposition it as shown noting the placement of its belt guide (E). 4.14 Grasp agitator firmly and fit it into position by first sliding end opposite the belt into the rectangular slot (F) on side of cleaner. Pull other side of agitator (G) into place. Turn agitator making sure belt is not pinched between agitator and agitator shield. 4.15 Reposition bottom plate and 4 Phillips head screws. Tighten screws securely. 4.12 B 4.14 What to Buy G Use only genuine HOOVER® Belt with your vacuum. When purchasing a new Belt, ask for HOOVER® Part No. 38528-033. The Agitator Brushroll: How to Replace ! CAUTION ! To reduce the risk of injury from moving parts, unplug vacuum before servicing. 4.16 When to Replace When agitator brushes are worn, the agitator should be replaced. To check condition of brushes, disconnect cleaner from electrical outlet. 4.16 Move edge of a card across bottom plate while turning agitator. To maintain cleaning effectiveness, replace agitator if brushes do not touch card. How to Replace Remove bottom plate, belt and agitator following directions in "BELT: How to Replace" section beginning with Fig. 4-10. Discard old agitator. Continue following the directions in "BELT: How to Replace" section to reposition belt, new agitator and bottom plate. What to Buy Your cleaner requires either a 13' or 15" agitator. When purchasing a new agitator, ask for one of the following: 13" - HOOVER part N 15" - HOOVER part 4.13 C D 4.15