Hoover C1703900 Manual - Page 15
Carpet Height Adjustment, Handle Position, Settings, Cleaning Lightweight, Flexible Rugs, Stair
UPC - 073502019429
View all Hoover C1703900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Carpet height adjustment Handle position The cleaning of carpet and rugs takes place at 2.8 For ease in sliding knob, the handle should be in 2.9 the nozzle (A). the upright position (C). When it is necessary to The nozzle will not move C raise and lower the nozzle into the adjusted position for various carpet pile B until the cleaner handle is heights, slide the nozzle control knob (B) to the lowered to the operating A position (D). D desired setting. Settings For maximum cleaning performance, the following carpet height settings are recommended: • Lowest setting: or all types of carpet. Note: If the cleaner is difficult to push, slide knob to the next higher setting. • Higher settings: for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance. 2.10 HIGH Cleaning lightweight flexible rugs Stand on one end of rug and move cleaner toward other end or edge. Before reaching edge, push down on handle. This will lift up the nozzle (front of cleaner) as shown and will prevent rug from clinging to cleaner. Continue to lift up nozzle so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower nozzle, and use only forward strokes. 2.11 Stair Cleaning 2.12 Lift vacuum by Stair Cleaning Handle and position on stairs. Clean forward to back. Never leave the vacuum standing on stairs when not cleaning. 2.12 HARD FLOOR 8