Hoover F5810 Manual - Page 9
Cleaning bare floors, Using the stair/upholstery nozzle - steamvac carpet cleaner
UPC - 719881157764
View all Hoover F5810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Cleaning bare floors rized Hoover Dealer (Depot), a Hoover Factory Service Center. With handle in the upright position, tilt carpet cleaning maothers, the tool is available at additional cost from your Autho- To clean floor "LIP" BARE FLOOR TOOL Disconnect carpet cleaning machine from electrical outlet. Return carpet cleaning machine to upright position. TANK HANDLE To prevent possible leaking, remove clean solution tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture.) HANDLE RELEASE PEDAL LATCH Step on handle release pedal and lower handle until it rests on the floor. Rotate recovery tank latches (one on each side of tank) outward; lift tank off machine. LATCH Lower handle and replace recovery tank. Press down to ensure that it is properly seated in place. Rotate latches (one on each side of tank) inward to lock tank in place. Raise handle to upright position. Dry hands and plug carpet cleaning machine into a properly Read "Before you begin cleaning" instructions on page 7. Do not use the 'SteamVac' carpet cleaning machine on hardwood floors. Fill clean solution tank according to instructions on pages 5 and 6. Use 5 ounces of HOOVER Bare Floor Cleaner. grounded outlet. To release solution, squeeze trigger. Slowly move carpet Step on handle release pedal and lower handle to operating position; turn carpet cleaning machine on. cleaning machine forward and backward over area to be cleaned. To pick up dirty solution, release trigger and slowly move carpet cleaning machine over area where solution has just been dispersed. Use both forward and reverse strokes. Your HOOVER 'SteamVac' carpet cleaning machine may also be TAB "LIP" chine back so that handle rests on the floor. Hold bare floor cleaning tool so that end with arrow is in your left hand and arrow points toward the ceiling. Place tab on other When finished cleaning, follow "After cleaning" instructions on page 7. Remove tool from nozzle and rinse in clear water. Do not remove sponge from tool. Using the stair/upholstery nozzle Some models come with the stair and upholstery tool kit. How to attach hose Disconnect carpet cleaning machine from electrical outlet. end of tool into groove in clear lip on front of nozzle (see illustration). Press firmly to snap end of tool with arrow into groove on opposite end of nozzle "lip". TANK HANDLE To prevent possible leaking, remove clean solution tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture). Cleaning bare floors - Using stair/upholstery nozzle 9