Hoover F7411 Manual - Page 7

ON/OFF switch, Handle release pedal, To transport, Automatic shut off, Carrying handle, Brush

Page 7 highlights

2-2 2-3 2-4 Rinse ON WASH OFF ON/OFF switch To turn cleaner ON, push switch down. To turn cleaner OFF, push switch up. A Handle release pedal Step on pedal (A) to lower handle to operating position. Handle does not lock into a single position but "floats" to allow convenient operation. To transport To move your deep cleaner from room to room, put handle in upright and locked position, tilt deep cleaner back on wheels and push forward. 2-5 2-6 2-7 B Carrying handle The deep cleaner may also be lifted by placing a hand above the upper clean solution tank handle as shown. Automatic shut off When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the deep cleaner suction (suction will be noticeably reduced). At that time, the yellow float disk will rise to the top of the recovery tank lid (B). The deep cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens, turn deep cleaner off and empty recovery tank before continuing use. Check clean water tank also; it may need to be refilled. Do not use without float and float retainer in place. If broken or dislodged, take to an Authorized Hoover Service Center or Dealer for repair. Brush setting selector Your 'SteamVac' deep cleaner has two agitator brush settings. ON - for cleaning of carpet and bare floors OFF - for cleaning carpets and bare floors when brushing is not desired. Slide selector button to the desired setting before cleaning. Continued § 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

7
2-2
ON
OFF
WASH
Rinse
ON/OFF switch
To turn cleaner ON, push switch down.
To turn cleaner OFF, push switch up.
A
Handle release pedal
Step on pedal (A) to lower handle to
operating position. Handle does not lock
into a single position but “floats” to allow
convenient operation.
To transport
To move your deep cleaner from room to
room, put handle in upright and locked
position, tilt deep cleaner back on
wheels and push forward.
2-3
2-4
Continued
Automatic shut off
When the recovery tank (lower tank) is full
the automatic shutoff mechanism will shut
off the deep cleaner suction
(suction will
be noticeably reduced).
At that time, the yellow float disk will rise
to the top of the recovery tank lid (B).
The deep cleaner will no longer pick up
dirty solution and the
motor sound will
become noticeably higher in pitch.
When this happens, turn deep cleaner
off and empty recovery tank
before
continuing use.
Check clean water tank also; it may
need to be refilled.
Do not use without float and float
retainer in place. If broken or dis-
lodged, take to an Authorized Hoover
Service Center or Dealer for repair.
Carrying handle
The deep cleaner may also be lifted by
placing a hand above the upper clean
solution tank handle as shown.
2-5
2-7
2-6
Brush setting selector
Your ‘SteamVac’ deep cleaner has two
agitator brush settings.
ON -
for cleaning of carpet and bare
floors
OFF -
for cleaning carpets and bare
floors when brushing is not desired.
Slide selector button to the desired set-
ting before cleaning.
B