Home > Hoover Manuals > Vacuums > Hoover H3060 > Manual Viewer

Hoover H3060 Manual

Hoover H3060 - FloorMate SpinScrub 800 Wet Dry Vacuum Manual

Get Hoover H3060 - FloorMate SpinScrub 800 Wet Dry Vacuum manuals and user guides
UPC - 073502027998
Free Hoover H3060 manuals!

Hoover H3060 manual table of contents:

  • Hoover H3060 | Manual - Page 1
    ENGLISH § pp. 1-20 ESPAÑOL § pág. 21-36 FRANÇAIS § p. 37-52 FloorMate™ SpinScrub™ 800 Hard Floor Cleaner www.hoover.com ®
  • Hoover H3060 | Manual - Page 2
    ... it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer. • Use cleaner only for its intended use as described in the instructions. C This appliance must be ...
  • Hoover H3060 | Manual - Page 3
    To contact us: • www.hoover.com • 1-800-944-9200 - automated service dealer locator • 1-330-499-9499 - our ... service of your cleaner. Carton Contents A. B. C. D. E. F. G. H. I. J. Hard floor cleaner Nozzle Upper handle Brush assemblies (2) Tool caddy Floor swivel tool Grout tool Telescoping ...
  • Hoover H3060 | Manual - Page 4
    ...3 This cleaner is intended for household use. Operate cleaner only at voltage specified on data plate on back of cleaner.... 20. 21. 22. 23. 24. 25. 26. Squeegee (underneath nozzle) Bumper Soft-tread wheels Hose ... Hose Telescoping wand Grout brush assembly (gray bristles) Floor swivel tool Grout tool 4
  • Hoover H3060 | Manual - Page 5
    ... 5 B Install brushes and nozzle 5 To install brushes, place handle in upright position. Tilt cleaner back so that it rests on the floor. A Align post (A) on brush block with hole (B) on bottom of cleaner. Turn brushes slightly until post fits easily into hole. ...
  • Hoover H3060 | Manual - Page 6
    ... snap into place. 7 To install nozzle, make sure latches (C) are out. 7 C D E Align middle section (D) of nozzle with opening (E) on cleaner. Remove cardboard packing insert from squeegee area on underside of nozzle. C 8 8 While holding nozzle in ...
  • Hoover H3060 | Manual - Page 7
    ... cut-out area (H). O Place hose end (I) into slot (J) on back of caddy. Place floor swivel tool (K), grout tool (L), brush assembly (M), telescoping wand (N) and ... to allow convenient operation. 15 ON/OFF switch A Push switch (A) once to turn cleaner 15 ON. Push switch again to turn cleaner OFF. 7
  • Hoover H3060 | Manual - Page 8
    ... 16 17 17 The cleaner may also be lifted using the carrying handle (A) on the front of the cleaner. A General operation Your HOOVER FloorMate™ SpinScrub™ 800 Cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces ...
  • Hoover H3060 | Manual - Page 9
    ... that contain solvent based ingredients. CAUTION: HOOVER® Floor to Floor™ Cleaning Concentrate and HOOVER® Grout Cleaner cannot be used in Hoover SteamVac™ products. Doing so could damage your SteamVac™ Cleaner. 23 C 23 Pour cleaning concentrate ...
  • Hoover H3060 | Manual - Page 10
    ... for proper performance and to prevent leaking. 25 26 26 Slide tank straight into position until... is built into the recovery tank to prevent the tank from overflowing. When the shut-off activates, the cleaner will not pick up debris and the sound of the motor will change. The recovery tank is full...
  • Hoover H3060 | Manual - Page 11
    How to empty 27 B Turn cleaner off and disconnect from electrical outlet. Although not necessary for satisfactory performance, ... reusable filter. Clean this pleated filter when suction is low or reduced. Turn cleaner OFF and disconnect from electrical outlet. 29 Remove recovery tank and lid (Figs. 27...
  • Hoover H3060 | Manual - Page 12
    ...and push tank straight into cleaner body until it is locked in place. E How to clean Recommended cleaning sequence Use your HOOVER® FloorMate™ SpinScrub™ 800 Cleaner to: • Dry Vacuum to remove loose dirt, hair and debris. • Wet Clean the floor ...
  • Hoover H3060 | Manual - Page 13
    Cleaning floors NOTE: Your HOOVER® FloorMate™ SpinScrub™ 800 cleaner may be used to clean wood floors that have been sealed with a polyurethane coating and can be cleaned with water. CAUTION: To prevent damage to wood floors, follow the flooring manufacturer's cleaning ...
  • Hoover H3060 | Manual - Page 14
    Using the tools 35 Select tool A. Floor swivel tool • Swivel head • 2 rows of brushes • Use... stains A B 35 Attach hose and tool Unplug cleaner from electrical outlet. How to connect hose 36 Open hose door (A) on side of cleaner.  Align hose connector (B) with hose and solution ports (C).  ...
  • Hoover H3060 | Manual - Page 15
    .... After attaching the tool to the hose, turn the cleaner ON. Put the tool against your hand ... that nothing is pressing on the nozzle squeegee. • Do not store cleaner on a wood surface unless ... convenience, the HOOVER® FloorMate™ 40 SpinScrub™ 800 tool caddy (A) is provided for storing the hose,...
  • Hoover H3060 | Manual - Page 16
    ...under running water. Remove debris from 45 squeegee (C) and wipe with a damp cloth. 45 ...replace nozzle, make sure latches (D) are out. Cleaner should be in the upright position for easier assembly .... Align middle section (E) of nozzle with opening (F) on cleaner. C 46 D E F 47 While holding nozzle...
  • Hoover H3060 | Manual - Page 17
    ... (A) out. Remove nozzle. A 49 B Tilt cleaner back so handle rests on floor. Push two brush release buttons (B) and remove the brush 49... latches (E) are out. Align middle section (F) of nozzle with opening (G) on cleaner. E 52 While holding nozzle in place, slide latches inward ...
  • Hoover H3060 | Manual - Page 18
    Troubleshooting Use the list below to help solve minor problems. What's the problem? Cleaner won't run ... positioned.  Check Model selector dial to ensure it is set for DRY VAC.  Tip nozzle off floor by pushing down on handle to pick up debris that is too large to clear the squeegee.  Make ...
  • Hoover H3060 | Manual - Page 19
    ... HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty ...an automated referral of authorized service outlet locations (U.S. only) Do not send your cleaner to The Hoover Company in North Canton for service; this will only result in delay...
  • Hoover H3060 | Manual - Page 20
    ...). For an automated referral of authorized service outlets in the U.S.A., phone 1-800-944-9200 OR visit The Hoover Company on-line at www.hoover.com This warranty does not ...1-330-499-9499. In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, 1-800-263-6376. (Domestic ...



Type your new search above

The manual viewer requires the flash plugin to be installed and enabled.
To view this page ensure that Adobe Flash Player version 10 or greater is installed.

Hoover H3060 - FloorMate SpinScrub 800 Wet Dry Vacuum Manual