Hoover S3592 Manual - Page 4
How to use - bags
View all Hoover S3592 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
2. How to use Cleaner description 2-1 1 2 6 3 4 16 15 3 13 17 18 7 10 5 6 4 20 8 12 14 11 9 21 The assembled cleaner will look like the drawing. Operate cleaner only at voltage specified on data plate on bottom of cleaner. This cleaner is intended for household use only. 2-2 B A 2-3 C 1. Hand grip 2. Power nozzle ON/OFF switch 3. Extension wand release buttons 4. Extension wands 5. Round swivel brush 6. Wand storage clip/tool holder 7. Upholstery tool 24 8. Power nozzle release button 9. Power nozzle 10. Headlight 11. Rug/floor pedal 12. Carrying handle 13. Hose connector 14. Filter bag door 15. Tool lid: stores crevice tool. Pull up on edge of lid in recessed area 16. Full bag indicator 17. Suction control slide switch 19 18. ON/OFF pedal 19. Cord rewind pedal: step on pedal 23 to rewind cord for storage. Hold plug until cord is rewound. 20. Large wheels: provide easy towing when cleaner is pulled over carpet, area rugs and door sills 21. Crevice tool (stores inside tool door) 22. Final filter door 22 23. Power cord 24. Wand holder slot Polarized plug To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 2-4 Turning cleaner on and adjusting power level After assembling cleaner, plug cord into electrical outlet. Turn cleaner ON by stepping on the ON/OFF pedal (A). The suction control can be increased or decreased by sliding the control (B) towards MIN or MAX. To turn cleaner OFF, step on the pedal. Cord rewind pedal The cord rewind pedal (C) is opposite the ON/OFF pedal. Hold on to the plug while cord is being rewound to prevent cord from whipping. Power nozzle Handle positions The handle has two positions when used with the power nozzle: upright and operating. To lower handle to operating position, place your foot firmly on the power nozzle and pull handle back.